Comment faire un diagnostic en utilisant OBDSTAR X300 DP Plus

3 HOW TO DIAGNOSE
3.1 CONNECT VCI CONNECTOR

Procedure to connect VCI connector:

1.Locate vehicle’s DLC socket. The DLC (Data Link Connector or Diagnostic Link

Connector) is the standardized 16-pin connector where diagnostic code readers interface with the vehicle’s on-board computer. The DLC is usually located 12 inches from the center of the instrument panel (dash), under or around the driver’s side for most vehicles. If Data Link Connector is not located under dashboard, a label should be there telling location. For some Asian and European vehicles, the DLC is located behind the ashtray and the ashtray must be removed to access the connector. If theDLC cannot be found, refer to the vehicle’s service manual for the location.

2.Plug the diagnostic connector into the vehicle’s DLC socket (It is suggested to use the OBD 2 extension cable to connect VCI connector and DLC socket.). For non-16PIN DLC socket, please select the corresponding non-16 pin connector adapter, then plug the non-16pin end of the adapter into the DLC socket, and then connect the standard 16pinend VCI connector.

3.2 DIAGNOSIS FLOWCHAT

For new users, please follow the 3.1 to get familiar with and start using this device. connect the diagnostic connector –>user registration–>user login–>download or upgrade software–>select function or vehicle type–>proceed diagnosis

3.3 USER REGISTRATION &DIAGNOSTIC SOFTWARE DOWNLOADING

3 .3.1 User registration
Click to enter diagnostic software, select “the user information” in “Settings”

menu, then enter user registration window. As shown in following photo:

Fill in the information in each field (Items with * must be filled). After inputting, tap “OK” If you have registered to be a member, click “the user information” to enter user login page, as following picture shown:

3.3.2 Download diagnosis software

Tap “One Key Upgrade” to enter one key upgrade page, as following picture shown:

Tap “One Key Upgrade” to start downloading, enter main interface after finishing downloading. (Notes: Ensure internet connection is normal when updating. Besides, because of many software, it may take several minutes, please wait patiently) If need to cancel a software, just tap corresponding Check Box as following picture shown:

3.3.3 Diagnostic software main interface introduction

Function menu included as follows:
Diag Program: operate as a diagnostic tool.

Maintenance Database: Provides abundant automotive technology, handbook and repair case for your reference.

Video Center: to guide users by video.

One Key Upgrade: To download diagnostic software or upgrade diagnostic software to the latest version.

Settings: It includes VCI information, language, unit, data records, user information, help, about.

Remote assistance: Realize remote hosting operation.

Report Center: Record maintenance data and diagnostic report.

Inspection Camera: To do a complete detection via flexible tube with HD camera into the vehicles.

3.4 START DIAGNOSING
Tap on the main menu screen, and then choose “Diag Program” to enter the function selection and vehicle selection page. As following photo shown:

Hereinafter, take OBDII for example, to introduce how to start diagnosing.

Tap “OBDII”, and tap “OBDII” icon. As following photo shown:

To select software version, as following photo shown:

To enter diagnostic function menu, as following photo shown:

To select AUTO SCAN, as following photo shown:

3.4.1 Read vehicle information

Tap “Read vehicle information”, as following photo shown:

3.4.2 Read trouble code

Tap “Read trouble code”, as following photo shown:

3.4.3 Clear trouble code

3.4.4 Read data stream