I want to change mileage on my W212 2013. Is only way to use MB CAN Filter ? I found some sugguestions on carprog but doesnt show steps
For example,if install mb can filter, do you still update ezs odometer value or just cluster ?Yes i know AVDI brites original does it all.
Anywhere else have to change it ? Tire pressure sensors of transimssion ?
Customer Solutions
1.Late 2013 Benz W212 you need to correct odometer and install CAN Filter. The can filter goes near the cluster.
I had done it with YanHua Digimaster III. It is not cheap, but i think you can use Digiprog 3.By the way, take backup from EEPROM first
2.If it is full color dashboard,digiprog3 cant do it
If it’s not facelift model(before 2013) and use digiprog 3 v4.94 then you dont need can filter/blocker.
But a can blocker is better to use all times, because if dealer reads the EZS it shows same mileage as in Tacho, if you dont use can blocker then EZS shows 99999km.(but normall dealers dont read
EZS, they only read assyst manager when serviced)
If you roll back odometer to a lower mileage off last service, its best to delete service history in car. Use option”assyst manager’ enter “774”days and “25000”kms for next service warning and press”V”
when it asks to delete service history.
When you have a diesel it probably gives DPF error in car. and the car will run in emergency-mode.
Only drives max 80kmh. Digiprog3 cant reset this. You have to go to dealer or some else who can reset DPF.
When some other errors turn up in display use the”clr” error option to reset.