How to update the CK-200 CK200 Auto Key Programmer?

How to update the CK-200 CK200 Auto Key Programmer?

V38.05 CK-200 CK200 Auto Key Programmer is the udated version of CK-100 Key programmer. Now the newest version is V38.05. How to update the 38.03 CK200 Auto Key Programmer to this version? Please follow the procedure.

Attention: A connector cable and a 12V/1A power adapter are necessary when you are going to upgrade CK200.
1.Click on the “CK200Upgrade” on the desktop and run the CK200Upgrade.exe program.
You can download the CK200SETUP from:

2.For the first time, click on the “DRIVE” button to install the CK200 drive.



Pop up a window after clicking on the DRIVE button.


The install is completed when “Press enter” is on the window,then you can close the window.

3.Inserted the 12V power line into the square hole in the side of CK200 at this time, CK200 is the normal state of running. Inserted one end of the upgrade line into the matching socket which is at the bottom of the CK200 inserted another end of the upgrade line into the USB which is on PC. There will be “Found new hardware” prompt display on the lower right corner, when prompted to “New hardware is installed and ready to use” means that the CK200 and the computer has been connected.
4.Click on “LOAD” button, and install the CK200 upgrading file.

5.After installing it successfully, click on “RENEW”.

6.After Clicking the RENEW button “Upgrading,please wait……” will be showing on the CK200 screen. At the same time,a progressbar will be showing on the interface of CK200 client programe.


7.When the “ReNewing completed! Run?” dialog box appears, Click “Yes” to complete the upgrade.At the same time,The CK200 is in normal operationState. Then, you can remove the upgrade cable and the power adapter.